23/07/2024 17:26:43

Center Console - Center Console Cupholder (Remove and Install)

Correction code 1519023061 FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the center console assembly from the vehicle. See reCenter Console - Center Console Assembly (Remove and Install).
  2. Remove the LH and RH center console external panels. See Center Console - External Panel Assembly - LH (Remove and Install).
  3. Remove the center console top decor assembly. See Center Console - Top Decor Assembly (Remove and Install).
  4. Release the clips (x7), disconnect the electrical connector, and then remove the center console inner panel.
  5. Remove the screws (x4), disconnect the electrical connector, release the electrical harness clip, and then remove center console wireless charger.
    5 Nm (3.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 bit
  6. Remove the screws (x10) that attach the center console cupholder assembly.
    5 Nm (3.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 bit
    Informational PurposesAn informational icon, calling your attention
    Note
    Lift upwards to remove the center console cupholder.

Install

  1. Install the screws (x10) that attach the center console cupholder assembly.
    5 Nm (3.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 bit
  2. Install the screws (x4) that attach the center console wireless charger, connect the electrical connector, and fasten the electrical harness clip.
    5 Nm (3.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 bit
  3. Install the center console top decor assembly. See Center Console - Top Decor Assembly (Remove and Install).
  4. Install the LH and RH center console external panels. See Center Console - External Panel Assembly - LH (Remove and Install).
  5. Install the center console assembly from the vehicle. See reCenter Console - Center Console Assembly (Remove and Install).
  6. Restore the LH and RH front seats back to their original position.
  7. Raise all the windows and close all the doors.