2024-07-23

1st Row Seat Belts - ZF First Row Buckle - Sumitomo (Remove and Install)

Correction code 2005001031 2005001032 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Move the LH front seat fully forward.
  3. Release the clips (x6) that attach the LH front seat inboard cover to the seat assembly, and then remove the cover from the assembly.
  4. Disconnect the LH front seat buckle electrical connector.
  5. Remove the bolt that attaches the LH front seat buckle to the seat assembly, and then remove the buckle from the assembly.
    45 Nm (33.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    The bolt is captive.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T50 socket

Install

  1. Position the LH front seat buckle onto the seat assembly, and then install the bolt that attaches the buckle to the assembly.
    45 Nm (33.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    The bolt is captive. Apply threadlock to the bolt if reinstalling the same buckle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T50 socket
  2. Connect the LH front seat buckle electrical connector.
  3. Position the LH front seat inboard cover onto the seat assembly, and then engage the clips (x6) that attach the cover to the assembly.
  4. Restore the LH front seat back to its original position.
  5. Raise the LH front window and close the LH front door.