2026-08-09

Underhood Apron - Rear (Remove and Install)

Correction code 1225127031 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2024-3-28: Added information on aligning the apron seal with the windshield seal.
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the powered frunk.
  2. Release the clips (x7) that attach the rear underhood apron to the vehicle, and then remove the rear underhood apron from the vehicle.

Install

  1. Position the rear underhood apron into the vehicle, and then secure the clips (x7) that attach the underhood apron to the vehicle.
    CAUTION
    Make sure the apron seal is positioned underneath the windshield seal.
  2. Close the powered frunk.