2024-07-23

Headrest - Center - 2nd Row Seat (Remove and Install)

Correction code 1305002061 1305002062 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH rear door and lower the LH rear window.
  2. Pull the tether to release the 2nd row armrest assembly, and then fold the armrest down.
  3. Separate the 2nd row center headrest from the armrest assembly.
  4. Use a pocket screwdriver to release the LH headrest post, and then simultaneously press the RH post latch while pulling the headrest away from the armrest assembly.

Install

  1. Position the 2nd row center headrest into the armrest assembly, push the headrest into the assembly until the posts engage, and then press the RH post latch to adjust the headrest to the lowest position.
  2. Fold the 2nd row armrest assembly to the original position.
  3. Raise the LH rear window and close the LH rear door.