2024-07-23

Door Trigger - Rear Door - LH (Remove and Install)

Correction code 1245011021 1245011022 1245011031 1245011032 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH rear door.
  2. Remove the LH sail baffle applique. See Exterior Trim Fittings - Sail Baffle Applique - LH (Remove and Install).
  3. Remove the LH C-pillar applique closeout. See Exterior Trim Fittings - C-Pillar Applique Closeout - LH (Remove and Install).
  4. Remove the LH C-pillar applique. See Exterior Trim Fittings - C-Pillar Applique - LH (Remove and Install).
  5. Remove the screws (x2) that attach the LH rear door trigger to the C-pillar applique, and then remove the door trigger from the applique.
    3 Nm (2.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket

Install

  1. Position the LH rear door trigger to the C-pillar applique, and then install the screws (x2) that attach the door trigger to the applique.
    3 Nm (2.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  2. Install the LH C-pillar applique. See Exterior Trim Fittings - C-Pillar Applique - LH (Remove and Install).
  3. Install the LH C-pillar applique closeout. See Exterior Trim Fittings - C-Pillar Applique Closeout - LH (Remove and Install).
  4. Install the LH sail baffle applique. See Exterior Trim Fittings - Sail Baffle Applique - LH (Remove and Install).
  5. Close the LH rear door.