2025-05-28

BLE End Point - Wheel Well - Front - RH (Remove and Install)

Correction code 1745104061, 1745104062 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Place the vehicle into Service Mode. See Service Mode.
  3. Release the clips (x11) and datums (x3) that attach the RH front fender flare cover to the vehicle, disconnect the electrical connector, and then remove the cover from the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    The camera harness is very short. Make sure not to pull the cover too far from the vehicles when releasing.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release all clips repeater connector before removal.
  4. Remove the clips (x14) that attach the RH front wheel liner to the fender flare carrier, and then release the wheel liner from the fender flare carrier and fascia.
  5. Remove the RH front fore fender flare carrier. See Carrier - Fender Flare - Fore - Front - LH (Remove and Install).
  6. Remove and discard the bolts (x2) that attach the RH front wheel well BLE endpoint to the vehicle, and then remove the endpoint from the vehicle.
    1.5 Nm (1.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit

Install

  1. Position the RH front wheel well BLE endpoint into the vehicle, and then install new bolts (x2) that attach the endpoint to the vehicle.
    1.5 Nm (1.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
  2. Install the RH front fore fender flare carrier. See Carrier - Fender Flare - Fore - Front - LH (Remove and Install).
  3. Install the clips (x4) that secure the RH front wheel liner to fore fender flare carrier.
  4. Position the RH front fender flare cover onto the vehicle, connect the electrical connector, and then secure the clips (x11) and datums (x3) that attach the cover to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Connect the fender flare camera electrical connector before installing the cover.
    Informational PurposesAn informational icon, calling your attention
    Note
    Replace any missing or damaged clips.
  5. Reinstall the vehicle software. See Software Reinstall - Touchscreen (Restore).
  6. Exit Service Mode. See Service Mode.
  7. Raise the LH front window and close the LH front door.