2024-07-23

Substrate - Back Rest - 2nd Row Seat - RH (Remove and Install)

Correction code 1308005071 1308005072 FRT 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the RH doors and lower the RH windows.
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Install).
  3. Disconnect MV power. See Mid-Voltage Power (Disconnect and Connect) (Modify).
  4. Remove the RH 2nd row side bolster. See Bolster - Outboard - LH - 2nd Row Seat Back (Remove and Install).
  5. Remove the RH 2nd row seat back inboard bolster. See Bolster - Inboard - LH - 2nd Row Seat Back (Remove and Install).
  6. Remove the bolts (x4) that attach the RH 2nd row seat back assembly to the vehicle.
    9 Nm (6.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  7. Release the clips (x4) that attach the RH 2nd row substrate to the seat back frame, and then release the substrate from the frame.
    Figure 1. LH shown; RH similar
  8. Release the connector lock, and then disconnect the RH 2nd row side substrate assembly electrical connector.
  9. Remove the RH 2nd row substrate assembly from the vehicle.
  10. Release the securing tabs (x13) and side rails (x2) that attach the RH 2nd row substrate trim and foam assembly to the substrate, and then remove the trim and foam from the assembly.

Install

  1. Position the RH 2nd row substrate trim assembly to the substrate, and secure the securing tabs (x13) and side rails (x2) that attach the trim and foam to the assembly.
  2. Position the RH 2nd row substrate assembly into the vehicle, and then connect the electrical connector and engage the connector lock.
  3. Secure the clips (x4) that attach the RH 2nd row substrate to the seat back frame.
  4. Install the bolts (x4) that attach the RH 2nd row seat back assembly to the vehicle.
    9 Nm (6.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  5. Install the RH 2nd row seat back inboard bolster. See Bolster - Inboard - LH - 2nd Row Seat Back (Remove and Install).
  6. Install the RH 2nd row side bolster. See Bolster - Outboard - LH - 2nd Row Seat Back (Remove and Install).
  7. Reconnect MV power. See Mid-Voltage Power (Disconnect and Connect) (Modify).
  8. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Install).
  9. Close the RH doors and raise the RH windows.