2024-07-23

BLE End Point - Rear (Remove and Replace)

Correction code 1745104042 FRT 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Install

  1. Install the rear BLE. See BLE End Point - Rear (Remove and Install).
  2. Install the rear fascia assembly. See Rear Fascia (Remove and Install).
  3. Connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect and Disconnect).
  4. In Toolbox, click the Actions tab, and then search for "Service-Redeploy".
  5. Click SERVICE CAN REDEPLOY, click Run, and allow the routine to complete.
  6. Disconnect Toolbox and remove the laptop from the vehicle. See Toolbox 3 (Connect and Disconnect).
  7. Exit Service Mode. See Service Mode.
  8. Raise the LH front window and close the LH front door.