23/07/2024 17:35:41

Undertray - Skid Plate (Remove and Install)

Correction code 1203128011 1203128012 FRT 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-06-03: Separated steps to provide more detail on releasing the tabs that attach the skid plate to the vehicle.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Press the brake pedal to turn on drive rails.
  3. Set the air suspension ride height to “Very High”.
    Informational PurposesAn informational icon, calling your attention
    Note
    On the vehicle touchscreen, navigate to Controls > Suspension > Off Road > Very High.
  4. Place the air suspension into "Jack Mode".
    Informational PurposesAn informational icon, calling your attention
    Note
    On the vehicle touchscreen, navigate to Controls > Suspension > Jack Mode
  5. Remove the LH and RH tow eye covers. See Front Grille and Applique - Lower Tow Eye Cap - LH (Remove and Replace).
  6. Remove the push clips (x4) and bolts (x8) that attach the undertray skid plate to the vehicle.
    4 Nm (2.9 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  7. Pivot the rear of the skid plate downwards and then forward to release the tabs (x8), and then remove skid plate from the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    The tabs may require some force to release. Be careful not to damage the front fascia.

Install

  1. Position the skid plate into the vehicle, and then engage the tabs (x8) that attach the skid plate to the vehicle.
  2. Install the push clips (x4) and bolts (x8) that attach the skid plate to the vehicle.
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure all the tabs (x8) are fully engaged before installing the fasteners.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  3. Install the LH and RH tow eye covers. See Front Grille and Applique - Lower Tow Eye Cap - LH (Remove and Replace).
  4. Remove the air suspension from "Jack Mode".
    Informational PurposesAn informational icon, calling your attention
    Note
    On the vehicle touchscreen, navigate to Controls > Service > Jack Mode
  5. Set the air suspension height to "Standard".
    Informational PurposesAn informational icon, calling your attention
    Note
    On the vehicle touchscreen, navigate to Controls > Suspension > Standard.
  6. Raise the LH front window and close the LH front door.