23/07/2024 17:35:27

Truck Bed - Rear Bed Closeout - LH (Remove and Install)

Correction code 1215125051 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the tailgate.
  2. Release the LH tailgate cable by disengaging the lock spring from the bolt, and then sliding the cable eyelet off.
  3. Release the clips (x6) and tab that attach the LH bed closeout panel to the vehicle, and then remove the panel from the vehicle.

Install

  1. Position the LH bed closeout panel to the vehicle, and then secure the clips (x6) and tab that attach it to the vehicle.
  2. Install the LH tailgate cable.
  3. Close the tailgate.