2024-07-23

Motor - Seat Height - 1st Row Seat - LH (Remove and Install)

Correction code 1301061091 1301061092 FRT 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.
  • 2024-04-02: Cleaned up topic.

Remove

  1. Remove the LH 1st row seat assembly. See Seat Assembly - 1st Row - LH (Remove and Install).
  2. Put the seat on a protected surface such as a 500 lb portable bench or similar.
    Informational PurposesAn informational icon, calling your attention
    Note
    Recommend assistance.
    Informational PurposesAn informational icon, calling your attention
    Note
    Put the seat so that the underside of the seat can be accessed.
  3. Remove the LH 1st row seat height motor bolts (x2).
    23 Nm (17.0 lbs-ft)
    18 Nm (13.3 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T45 socket
    Informational PurposesAn informational icon, calling your attention
    Note
    Electrical connector (x1)

Install

  1. Install the LH 1st row seat height motor bolts (x2).
    23 Nm (17.0 lbs-ft)
    18 Nm (13.3 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T45 socket
    Informational PurposesAn informational icon, calling your attention
    Note
    Electrical connector (x1)
  2. Install the LH 1st row seat assembly. See Seat Assembly - 1st Row - LH (Remove and Install).
  3. Calibrate the LH front seat using the vehicle touchscreen.
    Informational PurposesAn informational icon, calling your attention
    Note
    Touch Controls > Service > Drivers Seat, Steering & Mirrors Calibration > Start. Follow the on screen instructions. Allow the process to complete.
  4. Raise the LH front window and close the LH front door.