2026-03-05
Horizon Rail Assembly - Tonneau - LH (Long Range) (Remove and Install)
Correction code
11200100401,
11200100402
0.30
NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created.
NOTE: See Personal Protection to make sure you
are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy working practices.
Warning
This procedure is a DRAFT.
Although it has been validated, Warnings and Cautions might be missing. Follow safety
requirements and use extreme caution when working on or near High Voltage systems and
components.
- 2025-06-21: Released new procedure.
Remove
- Open the tailgate.
- Remove the LH sail applique. See Sail Applique - LH (Long Range) (Remove and Install).
- Remove the LH tonneau cam block. Cam Block - Tonneau - LH (Long Range) (Remove and Install).
-
Remove the fasteners (x9) that attach
the LH tonneau horizon rail assembly to the vehicle, and then remove the assembly from
the vehicle.
10 Nm (7.4 lbs-ft)TIpUse of the following tool(s) is recommended:- 8 mm socket x4 fasteners
- 10 mm socket x5 fasteners
Install
-
Position the LH tonneau horizon rail assembly into the vehicle, and then install the
fasteners (x9) that attach the assembly to the vehicle.
10 Nm (7.4 lbs-ft)TIpUse of the following tool(s) is recommended:- 8 mm socket x4 fasteners
- 10 mm socket x5 fasteners
- Install the LH tonneau cam block. Cam Block - Tonneau - LH (Long Range) (Remove and Install).
- Install the LH sail applique. See Sail Applique - LH (Long Range) (Remove and Install).
- Close the tailgate.