2026-08-09

BLE End Point - Interior (Remove and Install)

Correction code 1745104021 1745104022 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.
Warning
Cybertruck electronics are powered by a 48V "mid voltage" or "MV" architecture that is designed to improve efficiency. Servicing MV components requires extra knowledge and care in order to avoid personal and/or vehicular harm. Read and understand MV precautions in Electrical Precautions and make sure any required MV-related training courses have been completed, as applicable.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Install).
  3. Disconnect MV power. See Mid-Voltage Power (Disconnect and Connect) (Modify).
  4. Remove the front header trim. See Trim - Header - Front (Remove and Install).
  5. Remove the bolt that attaches the interior endpoint to the body, and then release the connector lock and disconnect the electrical connector.
    10 Nm (7.4 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket
  6. Release the clip that attaches the interior endpoint to the body, and then remove the endpoint from the vehicle.

Install

  1. Position the interior endpoint into the vehicle, and then secure the clip that attaches the endpoint to the body.
  2. Connector the interior endpoint electrical connector and engage the connector lock, and then install the bolt that attaches the interior endpoint to the body.
    10 Nm (7.4 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket
  3. Install the front header trim. See Trim - Header - Front (Remove and Install).
  4. Reconnect MV power. See Mid-Voltage Power (Disconnect and Connect) (Modify).
  5. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Install).
  6. Raise the LH front window and close the LH front door.