2024-07-23

Primary Seal - Door - Front - LH (Remove and Install)

Correction code 1020133031 1020133032 1020133011 1020133012 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH front door.
  2. Remove the LH front primary seal.

Install

  1. Install the LH front primary seal.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the drainage holes are facing the outside of the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Start with the corners.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use a dead blow as needed to secure fitment
  2. Close the LH front door.