Powergate (Manual Release)
Correction code 1010026005 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
-
Apply masking tape to work area
NoteEnsure lower fascia and powergate fascia are protected
-
Remove center applique
Note1x connector, Tabs will likely break, Pry outwards from bottom then pull down to release, Remove any debris if present, Release connector locking tab
-
Enlarge center hole of front end module
NoteDrill at upper section of oval opening, Drill through with 23mm bit from casting repair kit
-
Release powergate latch
NoteManeuver manual frunk latch release tool into hole, Rotate tool so tab is pointing upwards, Pull outwards while lifting upwards, Lever on latch will release, Push upwards on powergate while releasing to fully disengage latch
-
Remove masking tape
NoteWipe off any residue with IPA wipes
-
Remove frunk switch
Note4x tabs
-
Install frunk switch
Note2x tabs, Ensure switch is fully seated in applique assembly
-
Install front center applique
Note8x tabs, 1x connector, Ensure all tabs engage, Secure frunk release trigger connector
-
Close powered front trunk
NoteVia exterior switch or UI