15/01/2025 15:27:29

2nd Row Seat Covers and Pads - 2nd Row Outboard B Cover - RH (Remove and Replace)

Correction code NA NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
  1. Open RH rear door
    Informational PurposesAn informational icon, calling your attention
    Note
    Push RH C-pillar door trigger to release
  2. Lower RH rear window
  3. Partially release RH rear primary door seal
  4. Remove RH lower C-pillar trim
    Informational PurposesAn informational icon, calling your attention
    Note
    3x clips, 7x tabs, 4x datums, Starting at door sill pull upward then forward to release, Leave trim attached to seat belt
  5. Remove 2nd row RH outboard seatback bolster
    Informational PurposesAn informational icon, calling your attention
    Note
    2x tabs, 1x datum, 3x clips, Release tab near the bottom of RH outboard bolster, Partially release RH 2nd row shoulder cover and remove bolster from vehicle
  6. Remove clip securing RH 2nd row seat outboard B cover assembly
    Informational PurposesAn informational icon, calling your attention
    Note
    1x clip, Position aside for access to clip
  7. Release RH 2nd row seat cushion release buckle strap from lever and remove RH 2nd row seat outboard B cover assembly from vehicle
    Informational PurposesAn informational icon, calling your attention
    Note
    Compress material then twist away to release from groove
  8. Position RH 2nd row seat outboard B cover assembly into vehicle and secure RH 2nd row seat cushion release buckle strap to lever
    Informational PurposesAn informational icon, calling your attention
    Note
    Slide onto lever then compress material and twist inward to secure into groove
  9. Install clip securing RH 2nd row seat outboard B cover assembly
    Informational PurposesAn informational icon, calling your attention
    Note
    1x clip, Ensure strap is not twisted
  10. Install 2nd row seatback RH outboard bolster
    Informational PurposesAn informational icon, calling your attention
    Note
    2x tabs, 1x datum, 3x clips, Position LH outboard bolster into place, Ensure all clips and tabs are fully engaged, Replace any missing or damaged clips, Secure LH 2nd row shoulder cover, Perform push-pull-push test datums
  11. Install LH lower C-pillar trim
    Informational PurposesAn informational icon, calling your attention
    Note
    3x clips, 7x tabs, 4x datums
  12. Secure RH rear primary door seal
  13. Raise RH rear window
  14. Close RH rear door