2024-09-04
Isolator - Lower Spring - Rear - LH (Remove and Replace)
Correction code
31030032
0.78
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
- 2023-06-29: Added the whole procedure video as an overview for supplemental purposes only.
Warning
The video(s)
included in this procedure are meant as an overview for supplemental purposes only.
Follow all of the steps listed in the procedure to avoid damage to components and/or
personal
injury.
Remove
-
Remove the LH rear
suspension spring from the vehicle. See Spring - Rear Suspension - LH (Remove and Replace).
NoteIt is not necessary to remove the spring compressor from the spring assembly to remove the isolator.
- Remove the LH rear suspension spring lower isolator from the LH rear suspension spring.
Install
-
Install the LH rear
suspension spring lower isolator onto the LH rear suspension spring.
NoteAlign the top of the spring with the stop on the isolator.
- Install the LH rear suspension spring into the vehicle. See Spring - Rear Suspension - LH (Remove and Replace).