22/03/2024 00:30:26

Window Regulator (Recalibrate)

Correction code 11500010 0.05 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Figure 1. M3 Shown, MY Similar
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  1. Get into the driver seat, and then close the door.
  2. Use the touchscreen to enable Service Mode. See Service Mode.
  3. Unlock the vehicle Gateway: press and hold the brake pedal, and then push and hold the turn signal stalk fully up for approximately 10 seconds.
    Informational PurposesAn informational icon, calling your attention
    Note
    The MCU displays GTW UNLOCKING. Once the gateway is unlocked, the MCU will display GTW UNLOCKED as well as a countdown timer that indicates the remaining time in seconds for the gateway to be unlocked (max. 90 minutes).
  4. On the touchscreen, touch Controls > Service Mode > Closures > Windows > Calibrate Windows > Start.
    Informational PurposesAn informational icon, calling your attention
    Note
    During window calibration, all windows will roll up and down until window calibration is complete.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Pinch detection is disabled during calibration.
  5. Exit Service Mode. See Service Mode.