2021-08-11
Diamond Cover - Seat Side - 1st Row - RH (Remove and Replace)
Correction code
13072502
0.24
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Remove
- Remove the drive seat inboard side shield. See Side Shield - Inboard - Driver Seat (Remove and Replace)
- Disconnect 12V power. See 12V/LV Power (Disconnect and Connect)
-
Use the screwdriver to
disconnect LH front seat buckle connectors (x2).
-
Remove the diamond cover
clips(x2) from the LH front seat.
-
Remove the diamond cover
clips (x2) from the LH front seat.
-
Disconnect LH front seat
buckle connector and remove the diamond cover.
Install
- Install the diamond cover.
- Install the LH front seat buckle connector.
- Install the diamond cover clips (x4) from the LH front seat.
- Connect LH front seat buckle connector.
- Connect 12V power. See 12V/LV Power (Disconnect and Connect) .
- Install the drive seat inboard side shield. See Side Shield - Inboard - Driver Seat (Remove and Replace).