Cover - Rear Suspension - LH (Remove and Replace)
Correction code
31032012
0.48
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
- 2023-06-15: Added the whole procedure video as an overview for supplemental purposes only.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Bolt that attaches the rear suspension cover to the lower rear control arm assembly |
![]() 6 Nm (4.4 lbs-ft) |
|
Reuse |
Remove
- Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
-
Remove the bolt that
attaches the rear suspension cover to the LH lower rear control arm
assembly.6 Nm (4.4 lbs-ft)TIpUse of the following tool(s) is recommended:
- 10 mm socket
- 2 in extension
- Release the tabs (x2) that attach the rear suspension cover to the LH lower rear control arm assembly, and then remove the rear suspension cover from the vehicle.
Install
Installation procedure is the reverse of removal.