2020-03-05

Thermistor - Duct - Lower - RH (Remove and Replace)

Correction code 18104202 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the RH center console side panel carpet. See Side Panel - Center Console - LH (Remove and Replace).
  2. Release the clips that attach the RH lower duct thermistor to the HVAC assembly, and then partially release the RH lower duct thermistor from the HVAC assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Partially release the RH lower duct thermistor to allow the elecrical connector to be disconnected.
  3. Disconnect the RH lower duct thermistor electrical connector.
  4. Remove the RH lower duct thermistor from the HVAC assembly.

Install

  1. Partially install the RH lower duct thermistor into the HVAC assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Partially install the RH lower duct thermistor to allow the elecrical connector to be connected.
  2. Connect the RH lower duct thermistor electrical connector.
  3. Push the RH lower duct thermistor into the HVAC assembly until the retaining clips are fully secure.
  4. Install the RH center console side panel carpet. See Side Panel - Center Console - LH (Remove and Replace).