21/02/2023 06:03:58

Brake Hose - Flexible - Rear - LH (Remove and Replace)

Correction code 33030502 0.72 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 1079041-00-A Flare nut crowfoot set
Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Brake fluid dissolves paint. Have clean towels and plenty of water standing by to wash spilled brake fluid off painted surfaces.
Informational PurposesAn informational icon, calling your attention
Note
Dispose of used brake fluid in a manner consistent with local environmental codes.

Remove

  1. Disconnect 12V/LV power. See 12V/LV Power (Disconnect and Connect).
  2. Remove the rear LH wheel. See Wheel Assembly (Remove and Install).
  3. Position the oil drain under the rear LH brake hose.
  4. Remove the brake line tube nut from the brake hose at the jounce hose bracket, and allow the fluid to drain.
  5. Release the clip that attaches the brake hose to the jounce hose bracket, and then remove the hose from the bracket.
  6. Position the oil drain under the brake caliper.
  7. Remove the bolt that attaches the flexible brake hose to the brake caliper, and then remove the hose from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    The bolt and washers (x2) are captive and cannot be reused. Replace the hose assembly if the bolt is loosened or removed.

Install

  1. Position the LH rear flexible brake hose into the vehicle, and then install the bolt that attaches the hose to the LH rear brake caliper.
    42 Nm (31.0 lbs-ft)
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Make sure that the hose can bend forward and does not make contact with the wheel liner when the vehicle is lowered.
    Informational PurposesAn informational icon, calling your attention
    Note
    The bolt and washers are captive in the new hose assembly.
  2. Install the brake hose into the jounce hose bracket, and then fasten the clip that attaches the hose in the bracket.
  3. Insert the brake line into the brake hose at the jounce hose bracket, and then use a crowfoot extension to install the brake line tube nut into the brake hose.
    16 Nm (11.8 lbs-ft)
  4. Remove the oil drain from under the vehicle.
  5. Install the rear LH wheel. See Wheel Assembly (Remove and Install).
  6. Connect 12V/LV power. See 12V/LV Power (Disconnect and Connect).
  7. Bleed the brake caliper for the brake hose that was serviced. See Brake Fluid Bleed - One Caliper.