2026-08-09

Seal - Trunk (Remove and Replace)

Correction code 11702002 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Install

  1. Align the line on the trunk seal to the rear view mirror.
  2. Install the trunk seal to the perimeter of the trunk.
    Tip
    Tap the trunk seal with a rubber hammer and use a plastic trim tool to fully install the trunk seal to the body.
    Note
    Make sure the bottom of the seal is tucked into the rear fascia.
  3. Install the trunk sill trim. See Trim - Sill - Trunk (Remove and Replace).
  4. Pull the strings on the trunk seal to seat it flush across the interior.
  5. Install the rear trunk floor.
  6. Close the trunk.