2023-09-26
Tuner - FM / HD / DAB (Remove and Replace)
Correction code
21232102
0.24
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
- 2023-09-26: Add step for disconnect/connect 12V/LV power.
Remove
- Open the LH front door and lower the LH front window.
- Open the liftgate.
- Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- If the vehicle is equipped with HEPA filters, remove the HEPA filter assembly. See Assembly - Filter - HEPA (Remove and Install).
- Disconnect 12V/LV power. See 12V/LV Power (Disconnect and Connect).
- Remove the liftgate upper trim. See Trim - Upper - Liftgate (Remove and Replace).
- Remove the liftgate lower trim. See Trim - Liftgate - Lower (Remove and Replace).
- Disconnect the radio tuner electrical connectors (x2).
-
Remove the bolts (x3) that
attach the radio tuner to the liftgate assembly, and then remove the tuner
from the vehicle.8 Nm (5.9 lbs-ft)TIpUse of the following tool(s) is recommended:
- 10 mm deep socket
- Flex head ratchet/flex head torque wrench
Install
-
Position the radio tuner to the liftgate assembly, and then install the
bolts (x3) that attach the tuner to the liftgate.8 Nm (5.9 lbs-ft)TIpUse of the following tool(s) is recommended:
- 10 mm deep socket
- Flex head ratchet/flex head torque wrench
- Connect the radio tuner electrical connectors (x2).
- Install the liftgate lower trim. See Trim - Liftgate - Lower (Remove and Replace).
- Install the liftgate upper trim. See Trim - Upper - Liftgate (Remove and Replace).
- Connect 12V/LV power. See 12V/LV Power (Disconnect and Connect).
- If the vehicle is equipped with HEPA filters, install the HEPA filter assembly. See Assembly - Filter - HEPA (Remove and Install).
- Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- Close the liftgate.
- Raise the LH front window and close the LH front door.