2023-03-14

Seal - Inner Belt - Front Door - LH (Remove and Replace)

Correction code 11703202 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the LH front door trim panel. See Panel - Door Trim - Front - LH (Remove and Replace).
  2. Pull up to release the LH front inner belt seal from the door.
    Informational PurposesAn informational icon, calling your attention
    Note
    Remove the clips that remain in the door, and then install the clips into the rear of the inner belt seal.

Install

Installation procedure is the reverse of removal, except for the following:

  1. After installation is complete, calibrate the windows. See Window Regulator (Recalibrate).
  2. Confirm that the window operates correctly and without any abnormal noise.