Light - License Plate (Remove and Replace)
Correction code
17402602
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Remove
- Remove the liftgate upper trim. See Trim - Upper - Liftgate (Remove and Replace).
- Remove the liftgate lower trim. See Trim - Liftgate - Lower (Remove and Replace).
-
Disconnect the electrical connector from the license plate light.
-
Push the license plate light towards the RH of the vehicle to compress the clip, and then compress the clip on the other side of the light to remove the light.
Install
Installation procedure is the reverse of removal.