19/08/2020 12:59:12

B-Cover - Outer - 2nd Row - Center (Remove and Replace)

Correction code 13084502 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Remove

  1. Open all four doors and fully lower all windows.
  2. Move the front seats fully forward.
  3. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  4. Fold down the center 2nd row seatback assembly.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not place any additional weight on the seatback. Doing so may damage the seat frame alignment tabs, which can cause unevenness between the 60 and 40 seatbacks.
  5. Remove the center 2nd row headrest. See Headrest - 2nd Row - Center (Remove and Replace).
  6. Remove the center 2nd row backrest switch. See Backrest Switch – Seat Back – 2nd Row – Center (Remove and Replace).
  7. Use a trim tool to release the clips that attach the center back panel to the seat, working from the bottom of the seat towards the top, and then remove the panel from seat assembly.
  8. Remove the screw that attaches the 2nd row center/20 lumbar bun to the 2nd row seat.
    1.5 Nm (1.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  9. Fold the 60 seat to the upright position.
  10. Release the clips (x2) that attach the seat bun to the seat assembly, and then remove the seat bun from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull the bolsters outwards simulatenously to aid removal.
  11. Release the clip that attaches the center outer B-cover, and then pull the cover away from the seat.

Install

Installation procedure is the reverse of removal.