2025-07-10

Speaker - Headliner - LH (Remove and Replace)

Correction code 21214502 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Lower the front edge of the front headliner. See Headliner - Front (Remove and Replace). Follow the procedure until step 20.
    Informational PurposesAn informational icon, calling your attention
    Note
    For access to the headliner speaker, it is not required to fully remove the front headliner.
  2. Remove the soundproof foam from the LH front headliner speaker.
  3. Disconnect the LH front headliner speaker electrical connector.
  4. Remove the screws that attach the LH front headliner speaker to the headliner assembly.
    0.5 Nm (4 lbs-in)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T10 driver

Install

  1. Position the LH front headliner speaker onto the headliner assembly, and then install the screws that attach the speaker to the headliner assembly.
    0.5 Nm (4 lbs-in)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T10 driver
  2. Connect the LH front headliner speaker electrical connector.
  3. Install the soundproof foam to the LH front headliner speaker.
  4. Move the front headliner back to its original position. See Headliner - Front (Remove and Replace).