2026-07-14

Carrier - Side Shield - Outboard - Driver Seat (Remove and Replace)

Correction code 13070012 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Remove the driver seat outboard side shield. See Side Shield - Outboard - Driver Seat (Remove and Replace).
  2. Remove the driver seat outboard side shield carrier clips (x2).
  3. Remove the remaining clips that secure the driver seat outboard side shield carrier.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release the locating clips (x2) rearward. Then lift up and pull back to release the other three clips.

Install

  1. Install the clips that secure the driver seat outboard side shield carrier.
    Informational PurposesAn informational icon, calling your attention
    Note
    Align two rear clips from top to bottom and push forward to ensure they are fully seated. Then install the other clips (x3).
  2. Install the driver seat outboard side shield carrier clips (x2).
    Informational PurposesAn informational icon, calling your attention
    Note
    Push the clips inward.
  3. Install the driver seat outboard side shield. See Side Shield - Outboard - Driver Seat (Remove and Replace).