05/03/2021 08:37:04

Paint Protection Film - Rear Doors (Retrofit)

Correction code 12052006 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Procedure

Review the following Cautions prior to installing the Paint Protection Film Kit to avoid premature wear or peeling:

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Install the Paint Protection Film Kit in a dry and warm location. After installation, do not wash the vehicle and avoid rain for at least 24 hours.
Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
The LH and RH film pieces are not interchangeable; the sticky backing should be applied to the paint of the car and follow the contour of the body.
Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Do not allow any portion of the film to hang off the edge of the vehicle.
Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Make sure to remove all bubbles from the film pieces using the squeegee.
  1. Clean the installation areas with automotive soap and water, and then dry with a clean microfiber towel. Make sure all dirt, grease, etc. is removed.
  2. Create a slip solution by mixing approximately 85% water and 15% baby shampoo in a spray bottle or suitable container. Shake the container to make sure the solution is thoroughly mixed.
  3. Apply liberal amounts of the slip solution to the installation area and front side of the LH film.
  4. Release the LH film from the backing, applying slip solution to the back side as it is released.
  5. Adhere the LH film to the rear door, aligning the bottom of the film with the bottom of the door and the right side of the film with the end of the door.
    Informational PurposesAn informational icon, calling your attention
    Note
    Apply slip solution as necessary to maneuver the film so that it is aligned with the contours of the door and the entire film is adhered to the paint.
  6. Once the film is correctly positioned, use the squeegee to remove any air bubbles between the film and paint.
  7. Perform steps 3-6 for the RH side of the vehicle.