2023-05-16
Hinge - Door - Front - Lower - LH (Structural Pack) (Rework)
Correction code
11336603
0.18NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Remove
- Open the LH front door and lower the LH front window.
-
Use a floor jack to support the LH
front door from the bottom.
NoteMake sure to use a soft material such as a towel to protect the door paint.
- Apply tape to the LH front fender.
-
Apply tape to the LH front door and
body side lower hinge location.
NoteThis will mark where the hinge should align during installation.
-
Remove the bolts (x2) that attach the
LH lower front door hinge to the body.24 Nm (17.7 lbs-ft)TIpUse of the following tool(s) is recommended:
- 13 mm socket
- Use a trim tool to loosen the hinge from the body.
- Pull the hinge away from the body to gain access to the guided pins.
-
Remove the guided pins (x2) out of the
hinge using locking pliers (1115178-00-A or similar).
NoteRotate the pins during removal.
Install
- Position the hinge to its original position on the body.
- Hand-tighten the bolts that attach the hinge to the body.
- Close the LH front door.
-
Check the gap and flushness of the LH
front door.
NoteAdjust the LH front door, if necessary. Refer to CVIS for current specifications.
- Open the LH front door.
-
Tighten the bolts (x2) that attach the
hinge to the body.24 Nm (17.7 lbs-ft)TIpUse of the following tool(s) is recommended:
- 13 mm socket
- Remove the tape from the LH body side and door side of the lower hinge location.
- Remove the tape from the LH front fender.
-
Apply touch-up paint to the LH front
door hinge bolts.
NoteMake sure to shake the touch-up paint before applying.NoteAllow 1st coat to dry for 20 minutes before applying 2nd coat, if needed.
- Raise the LH front window and close the LH front door.