03/09/2021 00:32:46

Release Cable - Charge Port (3-Phase) (Remove and Replace)

Correction code 44013502 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open all four doors and lower the LH front window.
  2. Open the liftgate.
  3. Remove the LH lower C-pillar trim. See Trim - C-Pillar - Lower - LH (Remove and Replace).
  4. Remove the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
  5. Remove the front trunk load floor. See Trunk Load Floor - Front (Remove and Replace).
  6. Remove the trunk sill trim. See Trim - Sill - Trunk (Remove and Replace).
  7. Remove the LH trunk load floor bracket. See Bracket - Trunk Load Floor - LH (Remove and Replace).
  8. Remove the LH trunk pocket bracket. See Bracket - Trunk Pocket - LH (Remove and Replace).
  9. Remove the LH trunk side trim. See Trim - Side - Trunk - LH (Remove and Replace).
  10. Remove the LH upper C-pillar trim. See Trim - C-Pillar - Upper - LH (Remove and Replace).
  11. Remove the LH C-Pillar bracket. See Bracket - C-Pillar - LH (Remove and Replace).
  12. Remove the manual release cable:
    1. Pry out the clip that attaches the manual release cable to the charge port.
    2. Note the position of the rocker arm, and then carefully separate the rocker arm from the latch actuator assembly.
  13. Remove the manual release cable from the vehicle.

Install

  1. Install the manual release cable:
    1. Install the rocker arm to the latch actuator assembly.
      Informational PurposesAn informational icon, calling your attention
      Note
      Install the rocker arm in the same position as it was installed before removal.
    2. Install the clip that attaches the manual release cable to the charge port.
  2. Install the LH rear sill panel trim. See GUID-F372D367-AB8B-406C-9CCE-00C7545B7802.html.
  3. Install the LH C-Pillar bracket. See Bracket - C-Pillar - LH (Remove and Replace).
  4. Install the LH upper C-pillar trim. See Trim - C-Pillar - Upper - LH (Remove and Replace).
  5. Install the LH trunk side trim. See Trim - Side - Trunk - LH (Remove and Replace).
  6. Install the LH trunk pocket bracket. See Bracket - Trunk Pocket - LH (Remove and Replace).
  7. Install the LH load floor bracket. See Bracket - Trunk Load Floor - LH (Remove and Replace).
  8. Install the trunk sill trim. See Trim - Sill - Trunk (Remove and Replace).
  9. Install the front trunk floor trim. See Trunk Load Floor - Front (Remove and Replace).
  10. Install the rear trunk floor trim. See Trunk Load Floor - Rear (Remove and Replace).
  11. Close the tailgate, doors and window(s).