2025-09-12

Valance - Front Fascia (Remove and Replace)

Correction code 10012202 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Valance - Front Fascia (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Nut that attaches the RH corner of the front valance to the front fascia
3 Nm (2.2 lbs-ft)
  • 10 mm deep socket
  • Flex head ratchet/flex head torque wrench
Reuse

Remove

  1. Remove the front aero shield panel. See Panel - Aero Shield - Front (Non-Structural Pack) (Remove and Replace).
  2. Remove the clips that attach the front valance to the LH wheel arch liner.
  3. Remove the clips that attach the front valance to the RH wheel liner.
  4. Release the harness clip, and then disconnect the pedestrian warning harness connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull the locking tab to release the connector lock.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pedestrian warning speaker is located behind the RH wheel liner.
    Informational PurposesAn informational icon, calling your attention
    Note
    The connector access may vary depending on the version of the super horn audio speaker installed on the vehicle.
  5. Remove the nut that attaches the RH corner of the front valance to the front fascia.
    3 Nm (2.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm deep socket
    • Flex head ratchet/flex head torque wrench
  6. Remove the clips that attach the RH corner of the front valance to the front fascia.
  7. Repeat step 5 and step 6 for the LH side of the vehicle.
  8. Remove the clips that attach the front valance to the front fascia, and then remove the valance from the vehicle.
  9. Remove the screws that attach the pedestrian warning speaker to the front valance, and then remove the speaker from the valance.
    1.8 Nm (1.3 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx Plus IP25 socket
    • Flex head ratchet / flex head torque wrench
    • 2 in extension

Install

Installation steps are the reverse of removal, except for the following:

Informational PurposesAn informational icon, calling your attention
Note
If the new front valance is not equipped with fasteners preinstalled, transfer the side bolts (x2) and center mounted nuts (x2) from the old valance to the new valance.