04/09/2024 13:49:23

Garnish - Fender - Rear - LH (Remove and Replace)

Correction code 12201402 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  • 2023-06-15: Added the whole procedure video as an overview for supplemental purposes only.

Remove

  1. Release the clips (x12) that attach the LH rear fender garnish to the vehicle, and then remove the garnish from the vehicle.
    Tip: Starting from the center of the LH rear fender garnish, carefully pull the garnish away from the vehicle and work outward.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Be careful not to bend the tabs that attach the rear of the garnish to the rear fascia.

Install

Installation procedure is the reverse of removal, except for the following:

  • Position the rear fender garnish alignment tabs in the rocker panel and rear diffuser before installing the clips.
  • Once the rear fender garnish alignment tabs are installed, install the clips at each end of the fender garnish and work toward the center.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Be careful not to bend the tabs that attach the rear of the garnish to the rear fascia.