04/09/2024 16:52:16

Switch - Window - Driver (Remove and Replace)

Correction code 11502502 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-02-28: Added window switch removal tool 1988906-00-A.
  • 1988906-00-A - Window Switch Removal Tool
Figure 1. Model 3 shown; Model Y similar
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.

Torque Specifications

Table 1. Torque Specifications: Switch - Window - Driver (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the lower bolt cover to the LH front door trim panel
6 Nm (4.4 lbs-ft)
  • Torx T30 socket
  • 6 in extension
  • Cordless Ratchet/Impact Driver
  • Ratchet/torque wrench
Reuse

Remove

  1. Open the LH front door and fully lower the LH front window.
  2. Remove the bolt that attaches the lower bolt cover to the LH front door trim panel.
    Tip: Use of the following tool(s) is recommended:
    • Torx T30 socket
    • 6 in extension
    • Cordless Ratchet/Impact Driver
    • Ratchet/torque wrench
  3. Release the clips (x7) that attach the lower bolt cover to the LH front door trim panel, and then remove the cover from the door trim panel.
  4. Use a window switch removal tool (1988906-00-A) to release the tabs that attach the driver window switch to the LH front door trim panel.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Replace door trim if any tabs are broken during removal.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull up on the manual release handle for easy access to the special tool. Push up on the special tool to release the 4 tabs, and use your thumb to push down on the switch to release it from the left front door panel.
  5. Disconnect the driver window switch electrical connector, and then remove the switch from the vehicle.

Install

  1. Remove the jumper harness from the new driver window switch.
  2. Position the driver window switch into the vehicle, connect the electrical connector, and then secure the tabs (x4) that attach the switch to the door trim panel.
  3. Secure the clips (x7) to install the lower bolt cover to the LH front door trim panel.
  4. Install the bolt that attaches the lower bolt cover to the LH front door trim panel.
    6 Nm (4.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T30 socket
    • 6 in extension
    • Cordless Ratchet/Impact Driver
    • Ratchet/torque wrench
  5. Raise the LH front window and close the LH front door.