Bracket - Trunk Load Floor - LH (Remove and Replace)
Correction code
15305202
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Remove
- Open the liftgate.
- Release the LH rear passenger seat back, and then fold the seat back down.
- Remove the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
- Remove the front trunk load floor. See Trunk Load Floor - Front (Remove and Replace).
- Remove the trunk sill trim. See Trim - Sill - Trunk (Remove and Replace)
-
Pull upward on the LH load
floor bracket to release the tabs (x3) and clips (x2) that attach the
bracket to the vehicle, and then remove the bracket from the vehicle.
NoteThe 7-seater bracket is attached to the vehicle with 2 clips.NoteConfirm each installation with a push-pull test. The clip position should not be adjusted after the bracket is removed or it will result in the bracket not seating properly. If the clip position is changed or the push-pull action shows the bracket is not secure, remove the clip from the tab, and then seat the clip into the doghouse on the bracket and reinstall.
Install
Installation procedure is the reverse of removal.