2021-03-03

USB Hub - Seat - 3rd Row (Remove and Replace)

Correction code 13060042 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the 3rd row seat cushion. See Cushion - Seat - 3rd Row (Remove and Replace).
  2. Remove the 3rd row seat cup holder closeout. See Closeout - Cup Holder - Seat - 3rd Row (Remove and Replace).
  3. Remove the bolts that attach the 3rd row USB hub to the seat cushion assembly.
    1.5 Nm (1.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • Torx T20 bit
  4. Lift the 3rd row USB hub upwards to separate it from the 3rd row seat cushion assembly.
  5. Disconnect the 3rd row USB hub electrical connector.

Install

  1. Connect the 3rd row USB hub electrical connector.
  2. Slide the 3rd row USB hub downward into the 3rd row seat cushion assembly.
  3. Install the bolts that attach the 3rd row USB hub to the seat cushion assembly.
    1.5 Nm (1.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • Torx T20 bit
  4. Install the 3rd row seat cup holder closeout. See Closeout - Cup Holder - Seat - 3rd Row (Remove and Replace).
  5. Install the 3rd row seat cushion. See Cushion - Seat - 3rd Row (Remove and Replace).