11/05/2023 09:09:07

Bracket - Rucket - LH (Remove and Replace)

Correction code 15306112 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the LH load floor bracket. See Bracket - Trunk Load Floor - LH (Remove and Replace).
  2. Remove the push clip that attaches the trunk tub liner LH rucket bracket, and then partially release the liner for access.
  3. Release the clips (x2) that attach the LH rucket bracket to the vehicle, and then remove the bracket from the vehicle.

Install

  1. Position the LH rucket bracket into the vehicle, and then install the clips (x2) that attach the bracket to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Perform a push-pull-push test to verify the bracket is fully secure.
    Informational PurposesAn informational icon, calling your attention
    Note
    The clip position should not be adjusted after bracket is removed or it will result in the bracket not seating properly. If the clip position is changed or the push-pull action shows the bracket is not secure, remove the clip from the tab, seat the clip into the doghouse on the bracket, and then reinstall.
  2. Move the trunk tub liner into the original position, and then install the push clip that attaches the liner to the rucket bracket.
  3. Install the LH load floor bracket. See Bracket - Trunk Load Floor - LH (Remove and Replace).