2026-08-09

Bracket - License Plate - Rear (NA) (Remove and Replace)

Correction code 12072312 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Remove the screws (x2) that attach the rear license plate bracket to the vehicle, and then remove the bracket from the liftgate.
    1.2 Nm (.9 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T20 socket

Install

  1. Inspect and clean the install area on liftgate.
    Note
    Verify that thread inserts were not damaged during removal, and clean off the surface area from any dirt and debris.
  2. Position the rear license plate bracket to the liftgate, and then install the screws (x2) that attach the bracket to the liftgate.
    1.2 Nm (.9 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T20 socket