2026-08-09

Thermistor - Airwave Duct - RH (Remove and Replace)

Correction code 18104212 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. NOTE: See Ergonomic Precautions for safe and healthy working practices. NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Remove the front passenger knee airbag assembly from the vehicle. See Airbag - Knee - Front Passenger (Remove and Replace).
    Note
    It is not necessary to remove the closeout trim panel from the airbag assembly after removal.
  2. Disconnect the RH airwave duct thermistor connector.
  3. Use a 90 degree pick to release the tabs (x2) that attach the RH airwave duct thermistor to the duct assembly, and then remove the thermistor from the assembly.

Install

  1. Install the RH airwave duct thermistor into the duct assembly.
    Note
    Make sure both tabs are fully engaged.
  2. Connect the RH airwave duct thermistor connector.
  3. Install the front passenger knee airbag assembly. See Airbag - Knee - Front Passenger (Remove and Replace).