07/11/2023 03:10:30

Seal - Axle - Rear Drive Unit - LH (Remove and Replace)

Correction code 40301002 1.32 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Special tools required for this procedure:
  • 1454928-00-ATOOL, SEAL PULLER, ADJUSTABLE, MS/MX/M3
  • 1131206-00-A Install Tool, Output Seal, Model 3

Install

  1. Use the seal install tool to install the new seal into the rear drive unit.
    Informational PurposesAn informational icon, calling your attention
    Note
    Fully tap around the seal install tool to install the new seal. Make sure that the seal is fully flush with the rear drive unit casting.
  2. Install the LH rear drive unit halfshaft. See Halfshaft - Rear Drive Unit - LH (Remove and Replace).
  3. Refer to the Alignment Requirement tables to determine whether an EPAS alignment check (EC) or four wheel alignment check (AC) is necessary. If performed, add the alignment check/adjust as a separate activity. See Alignment Requirement - Suspension.