Garnish - Fender - Front - LH (Remove and Replace)
    
    Correction code
    
                           12201202
                           0.06
                           
        
          NOTE: Unless otherwise explicitly
          stated in the procedure, the above correction code and FRT reflect all of the work
          required to perform this procedure, including the linked procedures. Do not stack correction codes unless
            explicitly told to do so.
        
          NOTE: See Flat Rate
            Times to learn more about FRTs and how they are created. To provide feedback on
          FRT values, email ServiceManualFeedback@tesla.com. 
        
          NOTE: See Personal Protection to make sure wearing proper PPE when
          performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.
      
                        
  
- 2023-05-18: Added the removal procedure video for supplemental purposes only.
 
Remove
- 
          Release the push clips (2x)
                        that attach the LH front fender garnish to the front fascia.
          
 - 
          Release the clips (x11) that
                        attach the LH front fender garnish to the vehicle, and then remove the
                        garnish from the vehicle.
          TIpStarting from the center of the LH front fender garnish, carefully pull the garnish away from the vehicle and work outward.CAUTIONBe careful not to bend the front tabs that attach the front of the garnish to the front fascia.
 
Install
Installation procedure is the reverse of removal, except for the following:
- Position the front fender garnish rear alignment tab into the rocker panel before installing the clips.
 - 
          Once the front fender
                        garnish alignment tab is positioned, install the rearmost clip and work
                        toward the front of the vehicle.
          CAUTIONBe careful not to bend the front tabs that attach the front of the garnish to the front fascia.