25/11/2024 17:32:50

Buckle - 2nd Row - Center (7 Seat) (Remove and Replace)

Correction code 20057222 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2023-06-06: Added torque specifications and fixed missing/incorrect steps.
  • 2023-05-10: Rearranged procedure steps and added configuration instructions.
  • 2024-11-26: Add a note to clarify that harness should not be around bolt when install the buckle to seat assembly.

Remove

  1. Open the rear doors and lower the rear windows.
  2. Remove the LH 2nd row seat toe kick cover. See Cover - Toe Kick - 2nd Row Seat - LH (7-Seat) (Remove and Replace).
  3. Disconnect center 2nd row buckle electrical connector, and then release the connector from the seat assembly.
  4. Return the LH 2nd row seat to its original position.
  5. Move the RH 2nd row seat forward.
  6. Release the tabs (x4) that attach the RH 2nd row seat back inboard cover to the seat assembly.
    Tip: Release the front portion first, and then slide the cover straight rearward to clear the groove.
  7. Release the edge clip that attaches the cushion cover to the seat back assembly.
  8. Release the 2nd row center buckle harness from the LH seat back assembly.
  9. Remove and discard the bolt that attaches the center 2nd row buckle to the seat assembly, and then remove the buckle from the assembly.
    40 Nm (29.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 15 mm socket

Install

  1. Position the center 2nd row buckle to the seat assembly, and then install a new bolt that attaches the buckle to the assembly.
    40 Nm (29.5 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure to not pinch the wire between the bolt and the buckle bracket. Harness should not be around bolt.
    Tip: Use of the following tool(s) is recommended:
    • 15 mm socket
  2. Install the center buckle harness onto the LH seat back assembly.
  3. Install the edge clip that attaches the cushion cover to the LH 2nd row seat back assembly.
  4. Position the LH 2nd row seat back inboard cover onto the seat assembly, slide the cover forward into the grooved section, and then secure the tabs (x4).
  5. Move the LH 2nd row seat forward.
  6. Install the center 2nd row buckle connector onto the seat assembly, and then connect the connector.
  7. Install the LH 2nd row seat toe kick cover. See Cover - Toe Kick - 2nd Row Seat - LH (7-Seat) (Remove and Replace).
  8. Move the 2nd row seats to the original positions.
  9. Raise rear windows and close rear doors.