28/07/2020 14:08:58

Handle - Exterior Release - Door - Rear - LH (Remove and Replace)

Correction code 11452002 0.66 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
The side impact airbag deployment depends on the front door sensor's ability to detect a side impact from air pressure. Make sure that there are no uncovered holes in the front door shells. Additionally, always reinstall plugs or tape when servicing or inspecting the front doors and their components.

Torque Specifications

Table 1. Torque Specifications: Handle - Exterior Release - Door - Front - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Nuts that attach the LH front door exterior release handle to the door
7 Nm (5.2 lbs-ft)
  • 10 mm socket
  • ¼ in std ratchet
  • ¼ in torque wrench (installation only)
  • 6 in extension
Reuse

Remove

  1. Remove the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Install).
  2. Remove the rear LH door glass. See Glass - Door - LH - Rear (Remove and Replace).
  3. Remove the LH rear window regulator. See Window Motor / Regulator Assembly - Rear - LH (Remove and Replace).
  4. Disconnect the electrical connector from the LH rear door exterior release handle.
  5. Remove the plugs (x2) that covers access to the LH rear door exterior release handle nuts.
  6. Remove the nuts that attach the LH rear door exterior release handle to the door, and then remove the handle from the door.
    7 Nm (5.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not replace Nyloc nuts.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
    • 6 in extension

Install

Installation procedure is the reverse of removal, except for the following: