2021-07-16

Bracket - License Plate - Rear (EMEA and APAC) (Remove and Replace)

Correction code 12072302 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the screws that attach the rear license plate bracket to the vehicle, and then remove the bracket from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • T20 socket
    • 2 in extension

Install

  1. Verify the thread inserts were not damaged during removal, and clean the surface area with IPA wipes.
  2. Position the rear license plate bracket onto the vehicle, and then install the screws that attach the bracket to the vehicle.
    1.2 Nm (.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • T20 socket
    • 2 in extension