2020-06-05

Seal - B-Pillar Applique - LH (Remove and Replace)

Correction code 11700802 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Remove the B-pillar applique. See Applique - B-Pillar - LH (Remove and Replace).
  2. Release the B-pillar applique seal from the B-pillar applique.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull down on the bottom portion of the seal, and then release the sides from the applique channel.

Install

  1. Position the B-pillar applique seal onto the B-pillar applique.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the retaining tabs are tucked under the side seals.
  2. Install the LH B-pillar applique seal into the B-pillar applique channels.
  3. Remove residual adhesive from the LH B-pillar and clean the surface with an IPA wipe.
  4. Install the LH B-pillar applique. See Applique - B-Pillar - LH (Remove and Replace).