2022-08-23

Noise Filter - 12V - Antenna (Remove and Replace)

Correction code 21300502 0.06NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the liftgate upper trim. See Trim - Upper - Liftgate (Remove and Replace).
  2. Remove the liftgate lower trim. See Trim - Liftgate - Lower (Remove and Replace).
  3. Disconnect the 12V noise filter from the backlite glass.
  4. Remove the screw that attaches the 12V noise filter to the vehicle, and then disconnect the electrical connector.
    2 Nm (1.5 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx Plus IP30 socket
    • 4 in extension

Install

Installation procedure is the reverse of removal.