01/01/2024 23:51:28

Light - Fog / Reverse - Rear - LH (Remove and Install)

Correction code 17402701 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Light - Fog / Reverse - Rear - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Nut that attaches the rear fog/reverse light to the liftgate
3.5 Nm (2.6 lbs-ft)
  • 8 mm deep socket
  • 4 in extension
 Reuse

Remove

  1. Remove the liftgate lower trim. See Trim - Liftgate - Lower (Remove and Replace).
  2. Remove the nut that attaches the LH rear fog/reverse light to the liftgate.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 8 mm deep socket
    • 4 in extension
  3. Disconnect the electrical wiring harness connector from the LH rear fog/reverse light.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release the red locking tab to unlatch the connector, and then release the connector.
  4. Use a plastic trim tool on the outboard side of the light to release the anchors on the light from the grommets on the liftgate.
  5. Remove the LH rear fog/reverse light from the vehicle.

Install

  1. Replace the connector gasket and lower stud gasket on LH liftgate tail lamp .
  2. Install the LH rear fog/reverse light so that the anchors are inserted into the grommets on the liftgate. Make sure the LH rear fog/reverse light is fllush with the liftgate.
  3. Install the nut that attaches the LH rear fog/reverse light to the liftgate.
    3.5 Nm (2.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 8 mm deep socket
    • 4 in extension
  4. Connect the electrical wiring harness connector to the LH rear fog/reverse light.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the red locking tab is pressed down and the connector is fully connected.
  5. Install the liftgate lower trim. See Trim - Liftgate - Lower (Remove and Replace).
  6. Install the liftgate upper trim. See Trim - Upper - Liftgate (Remove and Replace).
  7. Close the liftgate.