14/09/2021 10:31:36

Shell - Seat Back - Driver (Remove and Replace)

Correction code 13041002 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Seat base edges are sharp and can cause personal injury. Wear cut resistant gloves when removing the seat from the vehicle, and while performing procedures that involve work on or near the seat base.

Remove

  1. Remove the driver headrest trim from the seat. See Trim - Headrest - Driver (Remove and Replace).
  2. Release the clips that attach the seat back shell to the driver seat, lift up on the shell to unhook it from the seat back frame, and lay the shell back.
  3. Release the clips that attach the shell apron to the underside of the seat, and then remove the shell from the seat.

Install

  1. Position the driver seat back shell onto the seat back, and then fasten the clips that attach the seat back shell to the seat back.
    Informational PurposesAn informational icon, calling your attention
    Note
    Install the lower clips first, and then rotate the shell up into position. Apply light pressure to ensure the seat back shell is fully seated.
  2. Hook the strap clips for the seat back shell onto the seat suspension.
  3. Install the driver headrest trim. See Trim - Headrest - Driver (Remove and Replace).