2020-02-20

Vent - Front - LH (Remove and Replace)

Correction code 14053102 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Vent - Front - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screw that attaches the LH front vent to the IP carrier
2.3 Nm (1.7 lbs-ft)
  • Torx T20 socket
  • 4 in extension
  • Ratchet/torque wrench
Reuse

Remove

  1. Remove the vent finisher. See Finisher - Vent (Remove and Replace).
  2. Remove the screw that attaches the LH front vent, and then pull out the LH side of the LH front vent to release it from the instrument panel.
    2.3 Nm (1.7 lbs-ft)
  3. Disconnect the electrical connector from the LH front vent, and then remove the LH front vent from the vehicle.

Install

Installation procedure is the reverse of removal, except for the following:

  • If the vehicle is left hand drive, make sure not to dislodge the foam block in the cavity where the front LH vent installs.